Shelf Life 18 months, Packaging Type Bag Waterproofing Coating Fosroc Cebex 100, Type Powder

Description plasticised expanding grout admixture ordinary cement slurry shrink shrinkage compensation with cebex 100cebex 100 is an admixture for cementitious grouts where areduced water/cement ratio and positive expansion isrequired. Applications include duct grouting, Bed grouting, Non, Shrink infilling and jointing. Advantages the system for gaseous expansion adjusts for plasticshrinkage as well as resolution in properly designedcementitious grout. Setting times reduced water/cement ratio mixes in the grout mixensures low permeability and long term durability inservice. Gives high grout fluidity with low water/cement ratio, Thus making placement or injection of the grout easy. No iron content in a metallic form to corrode and cause stainingor deterioration due to rust expansion in the grout. Composition allows outstanding initial strength development ingrouts, Excluding the application of of chlorides. Standards compliancecebex 100 is a suitable pre, Stressing grout admixture whencomplying with bs8110 part 1, 1985, Section 8. 9. 4. 6. Cebex 100 is offered in the form of a powder admixture. The materialis a blend of a plasticising agent and a gas producingexpansion medium. The plasticising agent allows the employment ofa reduced water/cement ratio with consequent increasedstrengths and durability. The expansive mediumcounteracts the natural settlement and plastic shrinkage ofthe grout and aids stability and cohesion. Sufficient restrained expansion is developed to ensure aelevated level of interfacial contact. All grouting specify details and areas of application mustbe carried out with a cement based grout incorporating aplasticised, Expanding powder admixture. The admixturemust be iron, Free and chloride, Free and shall be added tothe grout in the proportions 225 g of admixture per 50 kg ofcement. The admixture shall provide an expansion of up4% encased in plastic grout, Via a gaseous system. The admixture must handled and, Be stored mixed strictly inaccordance with the producer's instructions. Supplier specificationtechnical supportfosroc provides a technical advisory service for on, Siteassistance and advice on evaluationtrials and, Admixture selection dispensing equipment. Technical data andguidance is offered for supply for multiple options for admixturesand other products for fresh and hardened concrete. All grouting specify details and areas of application mustbe carried out using a cement based grout, Incorporatingcebex 100 manufactured by fosroc and applied strictly inaccordance with the manufacturer s technical data sheet. For best results a mechanically powered grout mixer mustbe used. For quantities up up to 50 kilograms a slow speed drill fittedwith a high shear paddle is suitable. Larger quantities willrequire a high shear vane mixer. It is essential that machinemixing capacity and labour availability is adequate to enablethe grouting operation to be carried out continuously. Thismay require the use of a holding tank with provision forgentle agitation to maintain fluidity. The selected watercontent should be accurately measured into the mixer. Slowly add the cement and sand if required and cebex100. Mix continuously for 5 minutes, Making sure that asmooth even consistency is obtained. Applicationareas to be grouted should be prepared to ensuresubstrates are clean, Sound, And then pre, Wetted. Theunrestrained surface area of the grout must be kept to aminimum. Place the grout within 20 minutes of mixing togain the full benefit of the expansion process. Adopt usual.