Three M Series Inline Helical Geared Motor, Mounting Foot flange, UsageApplication Industrial, Stroke 300 per mints

Series of product descriptions m inline geared motors and reducers provide a very efficient and compact drive solution to meet most requirements up to 160kw with maximum output torque capacity of 20000nm. The range takes advantage of many years of accumulated design expertise, Combined with the use Superior in craftsmanship materials and components. The end result is a range of speed reducing and geared motors offering high efficiency, Features a high load, Silent operation carrying capacity and reliability. The range includes 13 sizes of item equipped with a ratio coverage of 3. 6/1 to 56/1 in double reduction and up to 225/1 in triple reduction and 10000/1 in combined units. Unit versions available base or flange mounted unit type m, Motorised with iec standard motor unit type g, Unit to allow fitting of a standard iec motor unit type r, Reducer unit unit type s, Reducer unit with fan kit unit type w, Reducer unit with backstop ccw rotation unit type x, Reducer unit with backstop cw rotation unit type y, Reducer unit with fan and backstop cw rotation unit type z, Reducer unit with fan and backstop ccw rotationdesign features include patented standard motor connection iec . Ability to fit double oil seal data entry and retrieval as required. All units being suitable to fit iec standard motors. All units are dimensionally interchangeable with other major manufacturers. Brake motor systems designed with gears are available. Sizes 01, 02, 03, 04, 05, 06 and 07 are all supplied with lubricant. Sizes 08, 09, 10, 13, 14 and 16 are supplied without lubricant. Motorised units can be installed with a backstop module and reducer units can be fitted with a backstop and fan. As improvements in design are being made continually this specification is is not intended to be regarded as binding in detail and drawings and capacities are subject to alteration without notice. Certified drawings will be sent on request. A gear unit selection is made by comparing actual loads with catalogue ratings. Catalogue ratings are founded upon a standard set of loading conditions, Whereas actual load conditions vary according to type of application. Service factors are therefore used to calculate an equivalent load to compare with catalogue ratings. I. E. Equivalent load = actual load x service factormechanical ratings and service factors fm and fs mechanical ratings measure capacity with regard to life and/or strength, Assuming 10 hr/day continuous running under uniform load conditions. Catalogue ratings allow 100% overload braking or, At starting momentarily during operation up to 10 hours per day. The unit selected must therefore have a catalogue rating at least equal to half maximum overload. Mechanical service factor fm table 1 functions to modify the actual load according to daily operating time, And type of loading. Load characteristics for a extensive variety of applications are detailed in table 3 opposite, Which are utilized in deciding the appropriate service factor fm from table 1. If overloads can or accurately, Be calculated assessed, Actual loads should can serve instead of fm. For units subjected to frequent stop/starts overloads in excess of 10 times/day multiply factor fm x factor fs table 2 . For applications where units are to work in extremely dusty or moist/humid atmospheres unit selection should be referred to application engineering.