Bearing Retainer Adhesive, Brand Anabond, Packaging Type Tube

Description, Anabond 402 is a single component dimethacrylate ester based fast curing high strength anaerobic adhesive system tailored specifically for permanent bonding along with the closure of cylindrical fitting parts maximum strength is required. The product gets polymerized when confined between closely mating metal surfaces in the nonexistence of air and prevents loosening and leakage from shock and vibration. Product exhibits good temperature performance, Resistance to chemicals and lubricating property. Applications include locking bushings and sleeves into housings and on shafts. Curing performancethe product cures when confined in the absence of air between closed fitting metal surfaces. The curing time is influenced by the the kind of metal, Gap between the surfaces, Surface treatments and temperature. Assembly can be exposed to limited functional cure. Although functional cure is developed in a relatively short time, Curing continues for A minimum of 24 hours before full properties are developed. Tested according to atm, R031 iso 10964 r025 iso 10123 . General information before handling read product hazard information document and container label for safe use. This solution is not advised for utilization in pure oxygen or oxygen rich systems and not be selected as a sealant for chlorine or other strong oxidizing materials. To stop the product from clogging in the nozzle avoid allow the tip to touch the metal surfaces during application. Do not return the used product back to the original container as it could possibly be contaminated during usage. Where aqueous washing systems are applied for clean the surfaces before bonding, It holds significant value to verify the compatibility of the washing solution with the adhesive. In some cases these aqueous washes can affect the cure and performance of the adhesive. This item is not normally recommended intended for deployment on plastics, Particularly thermoplastic materials where stress cracking of plastic could result. Users are recommended to check the compatibility associated with the offering with such substrates. Substrate preparation all surfaces must be clean and dry for best results degrease the surface solvent and allow it to dry before applying the adhesive. If the metal surface is inactive or curing speed is slow anabond ekaprime, Use activator 021. Shake the product thoroughly before use apply required drops of the product on the of the mating area. Ensure the joint is completely filled with adhesive. Parts should not be disturbed until sufficient handling strength is achieved. For slip fitted assemblies, Apply adhesive around the leading edge of the pin and the inside of the collar and use a rotating motion during the assembly to ensure good coverage. For press fitted assemblies, Apply adhesive thoroughly to both bond surfaces and assemble at high press on rates. For shrink fitted assemblies the adhesive should be coated onto the collar, The pin s create sufficient clearance for free assembly disassembly and cleaning remove with standard hand tools. When hand tools do heat the, Not work assembly to approximately 2500c and disassemble while hot cured product can be remov soaking in a solvent and mechanical abrasion such as a wire brush. Storage store the material in its original container in a fashionable manner and dry condition between 8 and 35 heat source and direct sunlight. Storage other than recommend conditions will have effect on the features of the product.