Compression Type Dead End Fittings, UsageApplication AB Cable, Size 95 sqmm

We are able to provide compression dead end fittings complete with nuts bolts & jumpers, For all sizes of conductors & earthwires. Dead end clamps constructed with extruded aluminium alloy. Forged steel dead ends options are offered in link, Eye & clevis attachments. Compression type dead ending is most widely accepted practice on ehv lines due to its superior mechanical robustness and electrical continuity. For distribution line bolted these particular clamps are popular mainly without any maintenance advantage, Special tool because of, And continuity easier installation of jumper. However because of vibration and loosening problems quite often localized heating affects performance and cause outage. Compression type dead end for small diameter conductor has become popular mainly because of its superiority in electrical conductivity. These are very suitable for aac, Aaac & acsr conductor of small diameter. This installation is possible to accomplish by mechanical crimper having provision for changing dies suitable for hexagonal crimping. While for aac and aaac hand mechanical crimper is suitable for use upto a conductor diameter of 16 mm, For acsr this is not the case recommended above 14 mm size. The compression type dead end assemblies represent the best technical way to address the high voltage transmission lines both from mechanical and electrical point of view related to the ensuing reasons the dead end assembly has breaking load extremely near to the rated conductor strength . Rul guarantee ultimate strength equivalent to 95% ofthe breaking robustness of the conductor. The electrical ability to withstand the assembly when duly compressed on conductor is below 75% of the resistance of the equivalent length of conductor. The corona and radio interference characteristics are equal or better than those of the conductors. Earthwire dead ends are supplied with attachment fittings d shackles or clevis.