Brand Capaland Plus, Model Number XT 111 Floor Tile Adhesive, Packaging Type Bag

Description tile adhesive for indoor and outdoorcapaland plus classified as, Is cement, Based adhesive c1t according to standard une, En 12004 and iso 13007. Superior bonding, Highly thixotropic capability the essential elements in capaland plus give the product special guaranteeing perfect, Rheological characteristics tile application and reduce slip consequently of the copolymers incorporated in the mixture. Application surfaces conventional surfaces and cement, Based mortar floors and finishes. The application surface must perfectly set, Be hard and free from dust, Paint, Oil, Etc. Instruction for use add water and mix by hand or mechanically until you obtain a smooth paste of a workable consistency. Leave the paste to stand for 5 minutes and mix again before applying. Spread the paste on the surface in sections of a surface area no larger than 2 m2, Combing with a suitable trowel. If double gluing spread the, Is required mixture over the back of the tile as well. Put the ceramic tiles on leading edge of pressing lightly, The freshly, Laid adhesive to confirm that the whole tile surface comes into reach out to the adhesive, Filling any grooves. Leave a joint of a breadth a threshold of 2 mm between indoor tiles and at least 5 mm between outdoor tiles. Wait 24 hours before grouting wall tilles and 48 hours before grouting floor tiles. Respect all perimeter and structural joints. Place one partition joint every 50 m2 for indoor and one, Floor tiling every 30 m2 for outdoor floor tiling. Application tiling indoor floors and finishes and outdoor floors using ceramic tiles of medium/high porosity > 3% . A double glue technique should may function in the role of tiles larger than 900 cm2 30 cm x 30 cm . Warnings and recommendation avoid applying on dead plaster or weak renderings. Do not apply this product when frost or rain are forecasted. Do not apply in areas where you will find a risk of standing water. In extreme weather conditions wind or high temperatures, The product will dry more quickly than usual. This will produce a shorter open time. In high temperatures, Windy conditions or if the application surface is it serves, Very absorbent as advisable to moisten the surface and anticipate the film of water to disappear before applying the product. Check, Periodically, That a surface film has not formed on the adhesive paste once it has proven to be spread onto the uppermost level. If a film has formed, Remove the product and apply a fresh coat. Check that the paste is sticky enough by periodically lifting a leading tiles already in place to make certain that it is well stuck down. Use within 1 year of date of packaging. Store the offering contained in its original packaging in a dry, Covered place protected from humidity.