Universal Digital Controller, Input Sensor Thermocouple, Power 100 to 240 VAC, Controller Type Safety Limit Controller

The udc1200 & udc1700 are microprocessor, Based 1/16 din and 1/8 din controllers, Which combine a significant level of functionality and reliability at low cost. They are fully dedicated to monitor and control temperatures, Pressures and levels across a diverse selection of uses including environmental chambers, Furnaces, Ovens, Packaging machines and other applications in plastics and the food and beverage industries. The large and easy, To, Read dual 4, Digit display and tactile keypad make the udc1200 and udc1700 easy to configure and use. Their outstanding flexibility enables you to configure any unit for any application and change it if required. The following can be selected via the model selection guide rs485 ascii communication rs485 modbus rtu communication digital input alarms outputs 1, Two and three is tailored for use as alarms. Two electromechanical single pole double throw relays can activate external equipment when alarm setpoints are reached. An led is also activated on the front, Face. A direct or reverse acting alarm output can be configured. A logical combination of the two alarms or, And or hysteresis active when both alarms are active and inactive when both alarms are inactive is adjustable to fit which associates the two alarms status before energizing the relay. With the aim of detect a defective control loop, The controller can supply special loop alarm control by continually monitoring the pv response to output demand. A timer is automatically set up when any output is on saturation mode. When the timer reaches twice the reset time with no pv response, The loop alarm is activated. With this soft alarm not a single need for a heater saving wiring, Circuit breaker time and costs. Limit controller the udc1200 1/16 din limit controller provides a latched relay output acting as activated when the process parameters either exceed or fall bellow the providing a, Desired value failsafe cut, Off which must be considered manually reset before the process can continue. The udc1200 limit controller can be configured to be either a high limit unit where the delay will de, Energize when the pv is above the limit setpoint, Or a low limit, Where the relay will drop out when the pv falls below the setpoint. A led indicator shows when limits have and when, Been exceeded the relay is latched out. The optional digital input allows a remote reset function.